User's Manual

usage of Radio Frequency (RF) wireless devices are observed. Obey all signs
and instructions relating to the usage to RF wireless devices.
To reduce the potential risk of damage to the transmitter power amplifier
contained within this equipment, PowerTrunk recommend a duty cycle of 1
minute of transmit followed by 4 minutes of Receive/Standby specifically in
P25 mode.
Important safety notes about the antenna
Only use PowerTrunk approved antennas with this product. PowerTrunk
TETRA radios have been tested and certified for European and FCC safety
and compliance regulations using approved antennas.
This product must be used with the following antennas:
Model Antenna (part no.)
HTT-500-2
300-00498, 300-01938
The use of non-approved antennas may damage the product, will result in
the non-compliance with regulatory requirements, compromise the product
safety ratings, reduce the length of operating time and will invalidate the
product warranty.
NEVER touch the antenna when your radio is transmitting, this may cause a
minor burn to the skin and may affect the operational range of the antenna.
DO NOT handle, hold or swing your radio by its antenna, this may damage
your radio and the antenna.
NEVER use your radio if the antenna shows signs for damage.
Compliance
Federal Communication Commission (FCC) Regulations
PowerTrunk TETRA radios generate, use and radiate RF energy and, if not
installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications.
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
2
HTT-500-2 – 04/2017