User's Manual

Bellsouth feature list
Power Saving StartPower Saving Start
ü After Power On (3) seconds elapse
ü After stop transmitting (3) seconds elapse
ü After stop receiving (3) seconds elapse
Power SavingPower Saving releasing releasing
ü Transmission
ü Receiving(Carrier Detect)
ü Monitor Operation
ü FM Mode
FM RADIO MODEFM RADIO MODE
Press and hold menu button one time for above 1 sec to On/Off FM mode.
1. Volume control
Press the Up/Down Key to control the volume.
Not generate Volume Beep and limit warning Beep
2. Channel control
In FM Mode, With press the Menu Key to appear the FM Icon on the LCD as blinking
for (10) Seconds.
Press the Up/Down Key to control the desired Channel.
Press the Scan Key to start the Radio Frequency Seek function.
When an active signal is detected, Scan is paused keeping the active signal
broadcasted.
Press the Scan Key to pause the Seek Mode.
NOTICE TO USERS
The users manual or instruction manual shall include the following statement:
Warning: Adjustment to this unit or replacement of any transmitter component(crystal,
semiconductor, etc.) to this unit that could result in a violation of the rules.
NOTE; This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful Interference in a residential installation. This equipment generates, users
and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one
or more of the following measures: