User's Manual

Bellsouth feature list
the key to return to Stand-by Mode and Audio will be muted.
- CONTINUOUS MONITOR MODE
Press the Monitor key for more than (3) seconds, Continuous Monitor Mode will be
operated with Single Beep as BUSY(RX Icon appears on the LCD)
To release the Continuous Monitor Mode press the Monitor key twice as well as pressing
the PTT or Call key.
- In Monitor Mode channel and volume can be adjusted.
- Scan Skip Function
When an active signal is detected, But communication is not desired, press the monitor
button to bypass the channel and to continue scan.
Back Light On/OffBack Light On/Off
Press the Light Key shortly to light up the LCD display. The lamp will go out after (5)
seconds.
Key lock On/OffKey lock On/Off
Press the Light Key long till the Key Lock symbol is on the LCD
Volume and Channel Change is disabled during Key Lock Mode.
Press the Light Key same manner again to release Key Lock Mode.
Scan FunctionScan Function
The Scan activity is working in an endless channel loop from 1 to 14
Press Scan Key to activate channel scan
1. check the detected channel by the 200msec
2. Scan Icon symbol is on the LCD.
3. Resume time keeps for 4 seconds
4. When an active signal is detected , Scan is paused keeping the active signal
broadcasted.
Operate PTT or external PTT . then Scan is stopped ant the active channel
Low battery DetectLow battery Detect
When the battery level is low, the battery icon will flash to indicate that the batteries need
to be replaced
Power SavingPower Saving
The purpose of Power Saving is to maximize battery life.