User's Manual

Bellsouth feature list
EXTERNAL PTT
Transmit without using PTT Key as below
1. External Speaker Mike
2. External VOX On
INTERNAL VOX
When Internal VOX Mode is on,
VOX Sensibility level is controlled from 1 to 3 by Menu Key
While VOX Mode is on , VOX Icon is indicated on LCD
Call Function
Press and release the Call key for about (3) seconds to transmit an audible Call Tone. The unit
rings automatically returns to receive/stand-by mode when the Call transmission is over.
When call operation, all key is not operated except of Power Key
Monitor Function
Monitor Key is operated as below
1. Monitor On/Off
2. Continuous Monitor Mode On/Off
3. Scan Skip Function
- NORMAL MONITOR MODE
During pressing the Monitor key, Audio is On and RX Icon appears on the LCD. Release
the key to return to Stand-by Mode and Audio will be muted.
- CONTINUOUS MONITOR MODE
Press the Monitor key for more than (3) seconds, Continuous Monitor Mode will be
operated with Single Beep as BUSY(RX Icon appears on the LCD)
To release the Continuous Monitor Mode press the Monitor key twice as well as pressing
the PTT or Call key.
- In Monitor Mode channel and volume can be adjusted.
- Scan Skip Function When an active signal is detected, But communication is not desired,
press the monitor button to bypass the channel and to continue scan.
Back Light On/Off
Press the Light Key shrtly to light up the LCD display. The lamp will go out after (5) seconds.
Key lock On/Off
Press the Light Key long till the Key Lock symbol is on the LCD
Volume and Channel Change is disabled during Key Lock Mode.
Press the Light Key same manner again to release Key Lock Mode.