User's Manual

Bellsouth feature list
Power Saving
So as to maximize battery life, Power Saving Mode is automatically activated in 3sec after
every transmission and reception like following operation
The beginning of power saving is following.
The 3sec process of Power On
The 3sec process of stopping transmission.
The 3sec process of stopping receiving
The release of Power Saving is following
Transmission
Receiving ( Carrier Detect )
Monitor Operation
Error Indication
If it should occur error situation which impossible of TX/ RX, the radio make beep tone of 1
sec intervals.
NOTICE TO USERS
The users manual or instruction manual shall include the following statement:
Warning: Adjustment to this unit or replacement of any transmitter component(crystal,
semiconductor, etc.) to this unit that could result in a violation of the rules.
NOTE; This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful Interference in a residential installation. This equipment generates, users
and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction, may cause harmful interference to radio communication.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
needed.
Consult the dealer or an experienced radio/TV technician for help.
If shielded cables or special accessories are required for compliance, a statement must be included
which instructs the user to employ them, eg.
Shielded cables must be used with this unit to ensure compliance with the Class B FCC limits.