User Guide

ManualsBrandsTELRAN ManualsPoE SwitchTELRAN 4*10-100Mbps+2FE PoE Switch

Phone: 03-5575110 Fax: 03-5214524

office@telran.co.il www.telran.co.il Technical support *2023

p.n.560117

4*10/100Mbps+2FE PoE Switch

User Guide

4FE(PoE)+2FE

Package Contents

Check the following contents of your package:



PoE Switch x 1



User Guide x 1



Power Cord x 1



Accessories(Feet*4)

If any part is lost and damaged, please contact your local agent immediately.

Summary of content (5 pages)

PAGE 1
p.n.560117 4*10/100Mbps+2FE PoE Switch User Guide 4FE(PoE)+2FE Package Contents Check the following contents of your package:  PoE Switch x 1  User Guide x 1  Power Cord x 1  Accessories(Feet*4) If any part is lost and damaged, please contact your local agent immediately. Fax: 03-5214524 office@telran.co.il Phone: 03-5575110 www.telran.co.
PAGE 2
Introduction 4+2 100Mbps Provides the seamless network connection. The PoE ports (Port1~4) can automatically detect and supply power with those IEEE 802.3af/at compliant Powered Devices (PD). The electrical power is transmitted along with data in one single cable allowing you to expand your network where there are no power lines or outlets, where you wish to fix devices such as AP, IP Cameras or IP Phones, etc. It is easy to install and don’t need to configuration.
PAGE 3
LED indicator LED Color PWR Orange DATA Green PoE Orange Function Off: No Power supply. Light: Indicates the switch has power. Off: No device is connected to the corresponding port. Light: Indicates the link through that port is successfully established at 10/100Mbps. Blink: Indicates that the Switch is actively sending or receiving data over that port. Off: No PoE powered device (PD) connected. Light: There is a PoE PD connected to be port, which supply power successfully.
PAGE 4
Desktop Installation Install the Switch on a desktop, please attach these cushioning rubber feet provided on the bottom at each corner of the Switch in case of the external vibration. Allow adequate space for ventilation between the device and the objects around it. Wall-mounted installation In the first two fixed screw on the wall as shown in the figure below Aim at the two fixed hole switches, and the machine smoothly on the screw Turn on the switch The PoE switch can be used with AC power supply.
PAGE 5
Specifications Model 4+2 100Mbps Standard IEEE802.3, IEEE802.3u, IEEE802.3x, IEEE802.3af, IEEE802.3at Network Media(Cable) 10BASE-T: UTP category 3,4,5 cable (100m) 100BASE-TX: UTP category 5 cable (100m) MAC Address Table 2K, Auto-learning, Auto-aging Transfer mode Store-and-Forward Frame Forward Rate 10Base-T: 14881pps/Port 100Base-TX: 148810pps/Port Switching Capacity 1.