Product Specs

w
4
Purpose and Scope
The purpose of this document is to define product specification of 3GPP Rel10/11 Compliant LTE Cat
6 HE Outdoor CPE, support carrier aggregation, and Giga PoE Ethernet.
It describes the HW and SW requirements of the following products:
Company
Model Name
Product Name
Gemtek
WLTS- 110_424348
WLTS-110 LTE Cat 6 B42_43_48 TD-LTE HE
Outdoor CPE
Product Features
- Support TDD-LTE Mode Band 48
- Support 3GPP Release 10 compliant (Support Cat 6; 40MHz Carrier Aggregation) / Future Rel 11
- Support up to UE LTE Category 6 PHY Rate
- Support 1.8V and 3V SIM and USIM card for LTE Mode
- Support 1TX/2RX with TX switched diversity
- Supports Dynamic Host Configuration Protocol
- Built-in web server for web-based configuration
- Password protected access and configuration
- Supports IEEE 802.3, IEEE 802.3u, IEEE 802.3ab (10/100/1000 Mbps )
- Support Power over Ethernet of Outdoor WAN port {802.3 at}
- Supports VPN pass-through
- Support IP67 Environmental Proof
*B48 certification is in roadmap
** TDD Cat 6 with 40MHz carrier aggregation peak throughput is around 220Mbps @ TDD Config 2
SSF 7
Definitions, Acronyms and Abbreviations
LTE
Long Term Evolution
QoS
Quality of Service
MIMO
Multi-input Multi-output
OTA
Over the Air
RSRP
Reference Signal Received Power
RSRQ
Reference Signal Received Quality
RSSI
Received Signal Strength Indicator
CINR
Carrier to Interference plus Noise Ratio
SINR
Signal to Interference plus Noise Ratio
References
Date
Author
Document
Chapter 1 – Introduction