User's Manual

Telrad CPE12000 User Manual
CPE User Manual V1.5
6
1. Product Overview
This CPE supports LTE air interface with popular operating systems like Windows, Linux
and Mac.
Once you have identified the place for CPE, insert USIM card supplied by your service
provider at the appropriate place, plug in the adapter in the AC socket and DC in the power
port of CPE. Power On device, after few minutes the CPE should attach itself to the LTE
network. It is as simple as that. It is advised to read this manual at leisure to make best use
of the CPE. Products follow LTE standard protocols，When the product has no data
transmission, it will stop transmitting.
1.1. LTE Specification
See LTE module spec, below table is an example
Key features
Specification
3GPP Version
Release 12
UE category
Category 12
Bandwidth-No CA
10,20MHz
MIMO
2Tx/4Rx
UL/DL sub frame configuration
Configuration 1,2,3,4,5,6
Special sub frame configuration
0,1,2,3,4,5,6,7,8
Transfer mode
TM1, TM2, TM3, TM4, TM7,TM8,TM9
Data Speed
Down load420Mbps, Up load 30Mbps
1.2. Basic Specifications
Interface definition
RJ45
1 Giga Ethernet Ports with passive PoE PIN enabled（56V）
USIM interface
One USIM interface under the cover
Power supply
Power supply
Passive POE
Max power consumption
56V / 0.45A
Maxim length of Ethernet
cable
100 meters
Environmental Parameters