User's Manual

Telrad CPE12000 User Manual
CPE User Manual V1.5
13
Figure5-1-4 eNB Settings
 Preferred eNB List: Enable/ disable “preferred” selection checkbox.
When CPE performs scan it should build a list of all found eNBs, there have Few regions –
each region is sorted (top down)
Region A (top priority) – list of “preferred BS”, sorted by the relative eNB priority
Region B – eNBs from Home PLMN-ID or Equivalent PLMN-ID, not in the “preferred” list,
sorted by the best CINR
Region C – eNBs from the Last Registered PLMNID (if Roaming is enabled), sorted by the
best CINR
Region D – all the rest eNBs (if Roaming is enabled), sorted by the best CINR
Default value is disable, from Region B to Region D select Preferred eNB List. If Preferred
eNB List is enable, from Region A to Region D select Preferred eNB List.
 Lock ND&S to the preferred list: limit eNB selection to the “preferred” list only.
Condition – this checkbox should be possible only if “enable preferred list” is checked.
 Auto-Rescan Duration: Forces CPE to perform periodic re-scan/ re-connection
(Nomadic mode only) – in order to connect to the best/ preferred eNB according to the
“best eNB list”
Default value is 0-disable, hence in case the UE is attached to the first one in the list, the
UE will not rescan even it is configured.
 Preferred eNB list: configure “preferred” list
 Sorted eNB List: you can clean last found channels and refresh eNB list.
5.1.5 PDNs Settings
The default APN is “internet”, if you want to configure the LTE APN, you can add the new
APN and change default APN, then you can configure the APN settings by clicking on the