User's Manual

Page 3
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 , Subpart E of the FCC Rules. Operation is subject to the
following two conditions:
• This device may not cause harmful interference, and
• this device must accept any interference received including interference that may cause
undesired operation
Any unauthorized modification or changes to this device may void the user’s authority to
operate this device.
Furthermore, this device is intended to be used only when installed in accordance with the
instructions outlined in this manual. Failure to comply with these instructions may also void
the user’s authority to operate this device and/or the manufacturer’s warranty.
The grantee is not responsible for any changes or modifications not expressly approved by
the party responsible for compliance. Such modifications could void the user’s authority to
operate the equipment.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 50 cm
between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Industry Canada statement
This device complies with RSS-192 & RSS-197 of the Industry Canada Rules. Operation is
subject to the following two conditions:
• This device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause
undesired operation.
Ce dispositif est conforme à la norme CNR-192 & CNR-197 d'Industrie Canada applicable aux
appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions
suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif
doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un
fonctionnement indésirable.
Users can obtain Canadian information on RF exposure and compliance from the Canadian
Representative:
Nick Dewar
[e-mail]