System Manual

BreezeCOMPACT System Manual
96
Chapter 3: Operation and Administration
Procedures
Software Upgrade Via BreezeVIEW
3.4.2.6
Setting the BreezeCOMPACT Version in the Backup Bank as
the Main Software Version
The following procedure describes how to set the BreezeCOMPACT backup software version as
the Main software version.
¾ To set the backup version as the main software version:
1
At the B
BreezeCompact>
prompt, type the following:
BreezeCompact> request software-upgrade set-backup-as-main
The following message displays:
This action will set the backup software image as Main. Are You sure? [no,yes]
2
Type y
yes
.
3
Check the status by typing the following:
BreezeCOMPACT1000>show device
device general product-type COMPACT
device general product-subtype ENB
device general compact-model-type BreezeCompact1000
device inventory hw-ver 002-001-00
device inventory serial-number 95009785
device inventory main-sw-ver 0609.07395
device inventory backup-sw-ver 0609.07358
device inventory running-sw MainSW
device inventory boot-ver 0608.03.00045
device inventory up-time 2018-02-19T14:19:54+00:00
device inventory temperature 40
3.5
Software Upgrade Via BreezeVIEW
3.5.1
Purpose
This procedure describes how to upgrade LTE BreezeCOMPACT software using BreezeVIEW.
3.5.2
Procedure
Upgrading LTE software via BreezeVIEW involves performing the following steps:

Configuring TFTP as the BreezeVIEW IP
Address
,
page 97

Copying the BreezeCOMPACT Software to the TFTP
Server
,
page 97

Uploading the Software to a
Backup
,
page 97

Running the Software from a Backup
Version
,
page 99

Setting the Backup as the Main
Version
,
page 101