System Manual
BreezeCOMPACT System Manual
86
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
3.3.2.14
Applying Parameter Changes
Apply and activate the configuration by performing commit procedure in 3.1
¾ 4 In order to show the current cell neighbor list related
parameters in the ENB perform the following command from CLI
BreezeCompact% prompt :
show cell neighbor-list-cell
As a result the output should look like that :
neighbor-list-cell 1 1 {
eutra-carrier-arfcn 42590;
phy-cell-id 1;
qoffset 1;
cio 1;
rx-tx-power 15; black-listed false;
neighbor-ip-address 172.16.1.23;
}
neighbor-list-cell 1 2 {
eutra-carrier-arfcn 42591;
phy-cell-id 2;
qoffset 14;
cio 0;
rx-tx-power 22; black-listed false;
neighbor-ip-address 172.16.2.5;
}
3.3.3
Stop/Start all RH ports transmitting from BreezeVIEW
CLI
Open BreezeVIEW CLI and perform the following command to stop transmission
for the cell :
request devices device <device ID> live-status cell-actions-transmission stop-transmission cell-
identity <Cell ID>
To start transmission of all 4 ports perform the following command
request devices device <device ID> live-status cell-actions-transmission start-transmission cell-
iden
tity <Cell ID>
Command help:
start-transmission - Start Transmission of a selected Cell
stop-transmission - Stop Transmission of a selected Cell
Cell ID – perform operation on the specific cell ID (carrier)