System Manual
BreezeCOMPACT System Manual
85
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
To change the handover event to A3 use the following command:
set cell handover-triggers trigger-type A3
To set the HO triggers, define A3 offset value using the following commands:set
cell handover-triggers a3-offset <offset value>
In order to show the current handover trigers related parameters in the ENB perform the
following command from CLI BreezeCompact%: prompt:
show cell handover-triggers
As a result the output should look like that :
trigger-type A3;
a2-threshold-rsrp -140;
a3-offset 6;
To set the neighbors that participate in the X2 HO process, you must define the neighbor list.
The operator should define parallel definitions in the neighbor cell:
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> black-listed <true or false>
Indicates whether or not this neighbor cell is allowed as a handover target for UEs (true
– enabled false-not enabled).
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> cio < offset>
Specifies the individual cell offset that applies to a specific neighboring cell. This value is in
dB with an offset of 15, which means that the configuration of the parameter with a value of
15 is equal to 0dB.
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> eutra-carrier-arfcn <ARFCN>
Specifies the ARFCN of the neighbor carrier frequency.
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> neighbor-ip-address <X2 of
Neighbor IP Address>
Sets the neighbor X2 IP for signaling.
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> phy-cell-id <physical-cell-id>
Specifies the neighbor physical cell ID.
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> qoffset <qoffset>
Specifies the cell-specific offset that applies to a specific neighboring cell. This value is in dB
with an offset of 15, which means that the configuration of the parameter with a value of 15
is equal to 0dB.
set cell1 neighbor-list-cell <Cell ID> <eNodeB ID> rx-tx-power <RS Tx power in
DB>
Specifies the downlink reference-signal transmit power.