System Manual

BreezeCOMPACT System Manual
81
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
The following describes how to adapt QCI settings:
Telrad recommends to keep the QCI priority default settings, as changing them
may affect system QoS behavior. Contact Telrad Support for assistance if you need
to update the QCI table.
In order to show the current QOS s1-u-qis-list in the ENB perform the following command
from CLI BreezeCompact% prompt:
show qos s1-u-qos-list
As a result the output should look like that :
s1-u-qos-list 1 {
priority 2;
dscp-marking 0;
}
s1-u-qos-list 2 {
priority 4;
dscp-marking 0;
}
s1-u-qos-list 3 {
priority 3;
dscp-marking 0;
}
s1-u-qos-list 4 {
priority 5;
dscp-marking 0;
}
s1-u-qos-list 5 {
priority 1;
dscp-marking 0;
}
s1-u-qos-list 6 {
priority 6;
dscp-marking 0;
}