System Manual

BreezeCOMPACT System Manual
71
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
¾ To configure the bearer network:
 At the B
BreezeCompact%
prompt, set the bearer network parameters by entering
the following commands:
9
set networking lte-infrastructure enb-ip-address < eNB infrastructure IP address>
10
set networking lte-infrastructure subnet-mask <Subnet mask>
11
set networking lte-infrastructure next-hop-gateway <DGW IP>
12
set networking lte-infrastructure vlan-id <VLAD ID or NoVLAN>
13
For eEPC with EPC mode Enable,
set networking lte-infrastructure eepc-ip-address < IP address of the embedded EPC>
¾ To show the current configuration run the following command:
 show networking lte-infrastructure:
enb-ip-address 192.168.11.14;
subnet-mask 255.255.255.0;
next-hop-gateway 192.168.11.254;
vlan-id 11;
3.3.2.5
Configuring S1 Signaling
The S1 signaling IP list is used to connect to up to six EPC (MME) IP addresses, in order to
enable a redundant, load-balancing configuration. Using this configuration for multiple MME
IP addresses enables either load balancing or multiple PLMID capabilities. For more details,
see Section 1.5.6, Multiple PLMN IDs
and Section 1.5.7, EPC Redundancy and Load Balancing (Cluster).
¾ To configure an S1 signaling connection to the EPC BreezeWay2020:
 At the B
BreezeCompact%
prompt, enter the following command:
14
set networking s1-signaling link-server-list <MME IP address>
¾ In order to delete an existing configured s1 signaling connection to the EPC
BreezeWay2020:
 At the BreezeCompact% prompt, enter the following command:
15
delete networking s1-signaling link-server-list <Default MME IP address>
¾ To show the current configuration:
 At the Breezecompact% prompt , enter the following command:
16
show networking s1-signaling-servers-list As a result you will see the following output:
s1-signaling-servers-list 172.16.81.144;