System Manual

BreezeCOMPACT System Manual
70
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
Figure 42: BREEZEVIEW -ENB Antenna's status in DualCarrierAggregation
When looking on BREEZEVIEW->Home->devices-> ENB deployment tab :
Figure 43: BREEZEVIEW -ENB deployment tab when in DualCarrierAggregation
On BREEZEVIEW->devices->ENB ->cell0 tab:
Figure 44: BREEZEVIEW -ENB CELL0 deployment tab when in DualCarrierAggregation
On BREEZEVIEW->devices->ENB ->cell1 tab:
Figure 45: BREEZEVIEW -ENB CELL1 deployment tab when in DualCarrierAggregation
3.3.2.4
Configuring the Bearer Network
The Bearer network is used to enable an LTE S1 connection between the eNodeB and the
MME. It supports the S1-C, S1-U and X2 protocols over an SCTP connection.
The Bearer connection is defined on the same port as the management port, with a different
VLAN separation.