System Manual

BreezeCOMPACT System Manual
67
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
When running: show cell ran-rf
result is:
bandwidth 5MHz;
tx-power 30;
When running show cell0 general
result is:
cell-identity 0;
central-frequency 3510.0;
phy-cell-id 0;
When running show cell1 general
result is:
cell-identity 0;
central-frequency 3510.0;
phy-cell-id 0;
 show status ran port
result is :
PortsList 1 {
operational-status InService; admin-state InService;
}
PortsList 2 {
operational-status InService; admin-state InService;
}
PortsList 3 {
operational-status InService; admin-state InService;
}
PortsList 4 {
operational-status InService; admin-state InService;
}
On BREEZEVIEW when looking in Home->devices->ENB ->Device details:
Figure 38: BREEZEVIEW -ENB Antenna's status in DualCarrier
When looking on BREEZEVIEW->Home->devices-> ENB deployment tab :