System Manual

BreezeCOMPACT System Manual
66
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
Figure 35: BREEZEVIEW -ENB Antenna's status in SplitModef1f2
When looking on BREEZEVIEW->Home->devices-> ENB deployment tab :
Figure 36: BREEZEVIEW -ENB deployment tab when in SplitModef1f2
On BREEZEVIEW->devices->ENB ->cell0 tab:
Figure 37: BREEZEVIEW -ENB CELL0 deployment tab when in SplitModef1f2
As can be seen in Figure 27: BREEZEVIEW -ENB CELL0 deployment tab when in
SplitModef1f2 it is important to set F2 frequency when working on splitModef1f2
3.3.2.3.7
Dual Sector/Carrier:
The Dual Carrier topology enables a double-capacity BreezeCOMPACT. In this mode, the
BreezeCOMPACT behaves like two 2x2 eNodeBs (double capacity vs split mode).
On BreezeCOMPACT CLI from BreezeCompact% prompt perform the following in order to set:
 set deployment topology DualCarrier
 set cell1 general central-frequency <Frequency 1 in MHZ>
 set cell1 general central-frequency-f2 < Frequency 2 in MHZ>
 Perform commit procedure as per 3.1
When running: show deployment topology
Result is: topology DualCarrier;
When running: show ran rh-ports-admin-state
Result is: port1-admin-state Operative; port2-admin-state Operative; port3-admin-state
Operative; port4-admin-state Operative;