System Manual

BreezeCOMPACT System Manual
63
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
Figure 32: BREEZEVIEW -ENB deployment tab in single carrier 4Rx/4Tx DL MU-MIMO
3.3.2.3.5
SplitMode2X2:
The Split Mode 2x2 normal mode will use the same frequency for both sectors.
In order to change the deployment mode to SplitMode2x2 perform the following CLI command
from ENB from BreezeCompact% prompt:
 set deployment topology SplitMode2X2
 Perform commit procedure on 3.1
when running:

show deployment topology
result is:
topology SplitMode2X2;
When running:

show ran rh-ports-admin-state
result is:
port1-admin-state Operative; port2-admin-state Operative; port3-admin-state Operative;
port4-admin-state Operative;
When running from BreezeCompact> prompt :