System Manual

BreezeCOMPACT System Manual
62
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
 set deployment topology MuMimo
 Perform commit procedure as per 3.1
On BreezeCOMPACT1000>show ran
ran general min-freq 3400
ran general max-freq 3700
ran general max-tx 30
ran general port-config 4x4
PORT OPERATIONAL ADMIN
NUM STATUS STATE
1 InService InService
2 InService InService
3 InService InService
4 InService InService
BreezeCOMPACT1000%show ran
rh-ports-admin-state {
port1-admin-state Operative;
port2-admin-state Operative;
port3-admin-state Operative;
port4-admin-state Operative;
}
[ok]
On BreezeVIEW :
When clicking on the BREEZEVIEW home->devices->ENB ->device details:
Figure 31: BREEZEVIEW -ENB Antenna's status in single carrier 4Rx/4Tx DL MU-MIMO
When looking on Breeze view on the ENB deployment tab: