System Manual

BreezeCOMPACT System Manual
61
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
When running from > prompt : "show status ran port" you should see the following :
PortsList 1 {
operational-status InService; admin-state InService;
}
PortsList 2 {
operational-status InService; admin-state InService;
}
PortsList 3 {
operational-status InService; admin-state InService;
}
PortsList 4 {
operational-status InService; admin-state InService;
}
On BreezeVIEW :
When clicking on the BREEZEVIEW home->devices->ENB ->device details:
Figure 29: BREEZEVIEW -ENB Antenna's status in single carrier 4Rx/4Tx
When looking on Breeze view on the ENB deployment tab:
Figure 30: BREEZEVIEW -ENB deployment tab in single carrier 4Rx/4Tx
3.3.2.3.4
Single Carrier 4X4 with DL MU-MIMO
In order to change the topology to Single carrier 4x4 with DL MU-MIMO, On
BreezeCOMPACT CLI from BreezeCompact% prompt perform the following commands :