System Manual

BreezeCOMPACT System Manual
58
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
operational-status InService; admin-state InService;
}
PortsList 3 {
operational-status OutOfService; admin-state InShutdown;
}
PortsList 4 {
operational-status OutOfService; admin-state InShutdown;
}
The above means that 2 antennas (1,2) are operative and antennas 3,4 are not. Default topology
control in BreezeView :
Figure 25: BREEZEVIEW -ENB deployment tab when setting deployment topology as Default
topology
When looking on the BreezeVIEW ENB Advanced RAN tab:
Figure 26: BREEZEVIEW -ENB Advanced RAN tab when setting deployment topology as Default
3.3.2.3.2
Single Carrier 2T x/ 4Rx
In this mode 2 antennas in transmit mode and 4 antennas in receive.
In order to change the deployment mode to single carrier 2Tx/4Rx perform the following CLI
command from ENB from BreezeCompact% prompt:

set deployment topology SingleCarrier2X4

commit
when running:

show deployment topology
result is :
topology SingleCarrier2X4;
When running: