System Manual

BreezeCOMPACT System Manual
57
Chapter 3: Operation and Administration
Procedures
BreezeC
OMPACT Full Configuration via CLI
topology SplitMode2X2; wimax-coexisting true; enable-dcs false;
frame-structure { subframe-Cfg 2;
special-subframe-Cfg 0;
}
Figure 24: Deployment Tab in BreezeVIEW
3.3.2.3
Configuring deployment for an Antenna Topology
In this release, the supported modes are Single Sector and Dual Carrier/Split Mode 2x2. For more
details, see Section 1.5.1, BreezeCOMPACT Topologies.
 At the BreezeCompact% prompt, set the cell deployment topology of the antenna:
3.3.2.3.1
Default topology
-
single carrier 2Rx/2Tx
This is the default deployment topology. In case that it's required to set the deployment topology
to default topology the following steps should be considered:
The following command should be running from CLI from BreezeCompact% prompt:

set deployment topology DefaultTopology
 Perform commit procedure as in 3.1
When running:

show deployment topology
Result is:
topology DefaultTopology;
When running:

show ran rh-ports-admin-state
result is:
port1-admin-state Operative; port2-admin-state Operative; port3-admin-state ShutDown;
port4-admin-state ShutDown;
When running From BreezeCompact> prompt :

show status ran port
result is: PortsList 1 {
operational-status InService; admin-state InService;
}
PortsList 2 {