System Manual

BreezeCOMPACT System Manual
54
Chapter 3: Operation and Administration
Procedures
Configuration commit procedure
Chapter 3: Operation and
Administration Procedures
In This Chapter:

BreezeCOMPACT Full Configuration via
CLI
,
on page 56

Software Upgrade Via
CLI
,
on page 93

Software Upgrade Via BreezeVIEW,
on page 96

Resetting BreezeCOMPACT to Its Factory Default,
on page 103

Provisioning BreezeCOMPACT Using a Template,
on page 105

Locking and Unlocking a Device,
on page 109

Spectrum Analyzer Collection,
on page 112

Performance Monitoring,
on page 120
The following section will cover the relevant CLI commands in two ways:
3.1
Configuration commit procedure
The following procedure explains how to implement updates in CLI configuration.
After performing such updates follow the following steps at the BreezeCompact% prompt
1
C
Commit
2
A message "commit update" should show up in case that the validation check for the last
changes past successfully.
quit (it is not mandatory to exit from configuration mode to continue)
3
Once configuration changes are complete and committed. It is required to perform a reset to
activate the changes, at the BreezeCompact> prompt, type the following:
request reboot reboot
4
When the following message displays, type yes to confirm:
The reboot will disrupt all services provided by device. Are You sure? [no,yes]
The eNB as a result will reset then the eNB should come up with the updates implemented
configuration.