System Manual

BreezeCOMPACT System Manual

Chapter 2: Commissioning Steps

BreezeCOMPACT Commissioning

 L1 & L2 Port configuration (default Auto negotiate)

At the B

BreezeCompact%

prompt, set parameters by entering the following

commands:

set networking physical-ports-list

<Port number 1-3> d

duplex-mode

<fullDuplex

or HalfDuplex>

This command sets a port Duplex (half or full)

set networking physical-ports-list

<Port number 1-3> n

negotiation

<Auto or

manual>

This command sets a port negotiation to manual or Automatic mode.

set networking physical-ports-list

<Port number 1-3> s

speed

<100 ,1000> This

command sets the port speed to 100 or 1000 .

Important remark : For port 1: speed may be 1 Gb only For port 2: speed may be

100Mb or 1Gb only For port 3: speed may be 100Mb only in

BreezeCOMPACT1000 & 3000, in case of embbeded EPC 1000Mb can be set.

 Configure NMS BreezeVIEW IP address to permit auto discovery of the device.

set device management nms-ip

 Configure the TFTP server IP address (used for software version upgrade) –

TFTP server IP address (optional)

set device management tftp-ip-address

Perform license loading according to the procedure described in the Chapter 6, Licensing

Mechanism.

Perform commit procedure as explained in3.1

Reboot is required for changes to take effect

BreezeCompact> request reboot reboot

The reboot will disrupt all services provided by device. Are You sure? [no,yes] yes