System Manual

BreezeCOMPACT System Manual
50
Chapter 2: Commissioning Steps
BreezeCOMPACT Commissioning
2.1.2
Purpose
This procedure describes the steps required to initially commission the BreezeCOMPACT 1000,
2000 and 3000 and BreezeU100, in order to enable its connection for provisioning.
BreezeWAY1010 embedded EPC configuration is covered in BreezeWAY user manual
2.1.3
BreezeCOMPACT Commissioning Procedure
2.1.3.1
Initial Out-of-the-Box Connection
The following procedure assumes that the BreezeCOMPACT LTE software is already loaded
(already upgraded from WiMAX or shipped with the LTE software) and has been set to the
factory defaults.
¾ To connect the BreezeCOMPACT:
1
Connect the cable from the PC to the DATA3 Local Management port.
2
On the PC, define the IP address as 1
192.168.1.100
.
3
Connect the BreezeCOMPACT unit to the power supply and wait until the unit boots up.
4
Use any Telnet client software on the PC, such as putty.exe, to access the eNodeB using the
IP address 1
192.168.1.1
.
5
After a prompt is displayed, perform the following:
 Log in using a
admin
.
 Use the password LteAdmin!.
.
 At the B
BreezeCompact>
prompt, type c
configure
. The B
BreezeCompact%
prompt
displays.
It is recommended that you change the password. To change the password, see the
BreezeVIEW User Manual for more details.