System Manual

BreezeCOMPACT System Manual
Chapter 1: System
Description
5
Radio Frequency Interference Statement
This device complies with FCC Rules Part 15 and with Industry Canada licence-exempt RSS
standard(s). Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference that may be received or that may
cause undesired operation.
Canada: Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numerique de la classe B est conforme a la norme NMB-003 du Canada.
Frequency Stability
BreezeU100 & Comact1000 are based on OCXO oscillator with Max frequency stability of
200PPb, The OCXO is a 40 MHz device which feeds the RF component
The 40MHz OCXO is a standalone discrete part, while the other VCO’s are incorporated in the
RF component. The Oscillator and VCO’s are used in conjunction with a phase lock circuit on
the RF component in order to generate stable clocks and RF signals.
FCC and Industry Canada Radiation Hazard Warning
To comply with Industry Canada exposure requirements, and FCC RF exposure requirements
in Section 1.1307 and 2.1091 of the FCC Rules, the antenna used for this transmitter must be
fixed-mounted on outdoor permanent structures with a separation distance of at least 425 cm
from all persons.
Pour se conformer aux exigences d’exposition d'Industrie Canada, et aux exigences FCC dans
les sections 1,1307 et 2,1091 de la réglementation FCC, l'antenne utilisée pour cet émetteur
doit être montée d’une manière fixe sur des structures permanentes de plein air avec une
distance de séparation d'au moins 425 cm de toutes personnes.
Industry Canada Statement
Users can obtain Canadian information on RF exposure and compliance from the Canadian
Representative:
Nick Dewar