System Manual

BreezeCOMPACT System Manual
Chapter 1: System Description
BreezeCOMPACT R7.2 Software Capabilities
41
 Equal rate scheduling protection for low modulation CPEs (Weak UEs protection)
 UL QAM64 supported (On supported CPE models)

CAT12 Downlink 256QAM (with Selected CAT12 CPE’12000’s) (new in R7.2)
Higher Downlink throughput (per sector and per CPE)

Soft Frequency Reuse (SFR) (new in R7.2)
In case of Reuse 1 deployments where nearby cells operate in the same frequency.
 Spectrum analyzer – full band scan
 Spectrum analyzer (NI - Noise indication) – MAX NI during the last 5 min
measurements interval
 UE KPIs using CPE VIEW
 TDD configuration 0 - for enhanced Uplink as a demo mode
 SSF#7 (for up to 10Km radius)
 Frequency Selective Scheduling
(new in R7.2)
 Uplink Interference Protection for 5GHz bands (
(new in R7.2)

CBRS Band 48 Support:
 Compact1000
 CPE9000, CPE8100
(
EUD Support (please contact CS for latest SW versions):
 Maximum Tx power limit
 Channel Change
 Downlink RSSI measurement via TR-069

Services/ QOS:
 Default bearers (GBR or Non-GBR QCIs)
 Dedicated bearers (GBR or Non-GBR QCIs)
 Supporting PBR – QoS between multiple GBR bearers
 All QoS parameters support: QCI 1–9; GBR/MBR, AMBR with full rate policy
 Multiple PLMN-IDs support

Networking:
 S1 interface is 802.1q tagged - VLANs for LTE infrastructure and Management.
 DSCP and 802.1p policy-based marking at the infrastructure level for Control Plane
(LTE infrastructure VLAN), Management (Management VLAN) and User traffic (as per
LTE bearer QCI)
 eNodeB Ethernet statistics

Management
 Rollback management
 CLI User Authentication
 NTP – BreezeVIEW address is added
 Software Licensing
 Load Balancing of CPE’s between two carriers within the same geographical sectors
 Federated CBRS SAS Support Rel. 1.5 (please contact CS for latest SW versions)