System Manual

BreezeCOMPACT System Manual
117
Chapter 3: Operation and Administration
Procedures
Spectrum Analyzer
interval 200;
repetitions 0;
Quit from the configuration level to CLI level BreezeCompact% quit
3.10.2.3
Enable / Disable spectrum analyzer
¾ To enable spectrum analyzer:
 BreezeCompact> request spectrum-analyzer-actions enable-spectrum-analyzer
This action will enable the spectrum analyzer, the Tx ports will stop transmit. Are You sure?
[no,yes] yes
Spectrum analyzer will become enabled after several seconds. To verify state:
BreezeCompact> show spectrum-analyzer state spectrum-analyzer state (Enable/Disable)
3.10.2.4
Start scanning
BreezeCompact> request spectrum-analyzer-actions start-scanning This action will start the
scanning operation. Are You sure? [no,yes] yes [ok][2016-05-03 10:41:18]
BreezeCompact> show spectrum-analyzer state scanning-state
spectrum-analyzer state scanning-state Enable
3.10.2.5
Wait for scanning finished
The spectrum analyzer state will be Enabled as long as the scanning is performed, scanning-
state will be changed to Disable once scanning is finished. In order to monitor the state:
BreezeCompact> show spectrum-analyzer state scanning-state
spectrum-analyzer state scanning-state Disable
3.10.2.6
See the scanning results
To display results for all active ports:
BreezeCompact> show spectrum-analyzer scanning-results-list
¾ To display results for specific port number:
 BreezeCompact> show spectrum-analyzer spectrum-scanning-results-list
antenna-port <Port Number>
¾ To show the full table (without need for pressing enter):
 BreezeCompact> show spectrum-analyzer spectrum-scanning-results-list |
nomore
Example for results operating Spectrum analyzer with interference on central frequency of
3655000kHz and 10MHz Bandwidth:
BreezeCompact> show spectrum-analyzer spectrum-scanning-results-list antenna-port 2