System Manual

BreezeCOMPACT System Manual
103
Chapter 3: Operation and Administration
Procedures
Resetting BreezeCOMP
ACT to Its Factory
Defaults
3.5.2.5.1
Software Upgrades and System Events
The events associated with the upgrade procedure can be viewed in the System Events
window.
Figure 82: System Events Window
The Load SW to Backup operation ends with the following two events:
 Download-To-Backup-Started
 Download-to-Backup-Completed
The Reset from Backup operation shows one event: External-Reset.
The Set Backup as Main operation shows one event: Set-Backup-as-Main.
3.6
Resetting BreezeCOMPACT to Its Factory
Defaults
3.6.1
Purpose
This procedure describes how to reset the BreezeCOMPACT configuration to the factory
default configuration. The factory default configuration sets all parameters to their vendor
factory defaults, except External Management parameters, the BreezeVIEW IP address and
the Device ID.
3.6.2
Procedure
The BreezeCOMPACT automatically resets after performing the procedure below.
¾ To reset the BreezeCOMPACT configuration to its factory default
configuration:
1
Select the Rese
et
to F
Factory Defaults
option using one of the following methods:
66 In the R
Reset
action menu in the Devices window, select the S
Set Factory Defaults
option.
67 In the
Device Details window, select a device and then select the S
Set Factory Defaults