User Manual

BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBS Menu
Chapter 3 - Operation and Administration BS Menu
78
3.7.2.6.4.3 Secondary Pool
The Secondary Pool option enables viewing the IP Address and current Connectivity Status for each of
the ASN-GWs in the pool, based on selection of the ASN-GW Index.
3.7.2.7 Management Thresholds
The Management Thresholds menu includes the following option:
 Noise and Interference Level Thresholds
3.7.2.7.1 Noise and Interference Level Thresholds
The Noise and Interference Level Thresholds menu enables viewing/updating the values configured for
the following parameters:
 Uplink Median Noise
 Throughput Active Second Threshold
3.7.2.7.1.1 Uplink Median Noise
The uplink median noise level represents the median value of the noise floor histogram. If the uplink
median noise level exceeds this value, an excessive uplink median noise alarm will be generated.
The value is in dBm/tone. The default value of -124 is set to 3 dB above the default value of the Target NI
parameter.
The range is from -135 to -100 (dBm).
3.7.2.7.1.2 Throughput Active Second Threshold
The BS Traffic Performance Parameters counters collected by the file collection mechanism include
throughput counters (bsDlMimoABfActualThroughput, bsDlMimoBActualThroughput,
bsUlActualThroughput). These counters collect the number of bytes transmitted/received during each 15
minutes collection interval using different modulation techniques, and the relevant numbers of “active”
seconds. “Active seconds are defined as seconds during which the relevant throughput was not below a
the threshold defined by the Throughput Active Second Threshold.
The range is from 0 to 2147483647 bytes per second.
The default is 0.
3.7.2.8 Keep Alive
The Keep Alive menu enables viewing/updating the values configured for the following parameters of
the keep-alive mechanism between the BS and the relevant ASN-GWs:
 Enable Keep Alive
 Polling Period
 Number of Retransmissions
 Retransmissions Time Out