User Manual

BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationSector Menu
Chapter 3 - Operation and Administration Sector Menu
59
The default is none. A valid option must be selected.
A change in Bandwidth will take effect after next reset.
3.6.2.2 Center Frequency
The center downlink frequency of the Radio Cluster, in MHz. The valid values are from f1+0.5BW to
f2-0.5BW, where f1 is the lowest frequency of the band supported by the radio head (see RH Menu,
“General” on page 88), f2 is the highest frequency of the band, and BW is the defined Bandwidth.
The default is 0. A valid value must be configured.
A change in Center Frequenct will take effect after next reset.
3.6.2.3 TX Power
The required tx power of the Radio Cluster, in dBm.
The actually valid range depends on Installed RH Type: The upper limit is set by the Maximum Tx Power
supported by the radio head (see RH Menu, “General” on page 88). The lower limit is the Maximum Tx
Power supported by the radio head minus 10dBm.
The default is 0. A valid value must be configured.
3.6.3 Antenna Association
The Antenna Association menu enables viewing and updating the Antenna And Antenna Port for each
antenna association entry. Actual physical connections must match the configured values and the
operation mode configured for relevant ports (see “Ports Control” on page 82).
The selection key for each entry is the RF Port Number(1-4).
A change in Antenna Association will take effect after next reset.
The configurable parameters for each RF Port are:
3.6.3.1 Antenna Number
A number in the range from 1 to 4.
The default is null. The relevant Antenna Number as specified in “Antenna Menu” on page 90 must be
configured.
3.6.3.2 Antenna Port Number
A number in the range from 1 to 4.
The default is null. The relevant Antenna Port Number (according to the number of ports supported by
the selected antenna) must be configured.
Each port cannot be used more than once (each combination of Antenna Number and Antenna Port
Number must be unique).