User Manual
Table Of Contents
- System Manual
- BreezeCOMPACT
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration BTS Menu
47
The External Management Next Hop Gateway must be within the range defined by External
Management IP Address and External Management Subnet Mask.
The default is 192.168.1.1 (an IP address 0.0.0.0 is a valid value if IP address of external management
equipment is within the range defined by External Management IP Address and External Management
Subnet Mask).
In Unified Connectivity Mode the External Management Next Hop Gateway should be configured to the
same value as the Bearer Next Hop Gateway.
A change in External Management Next Hop Gateway will take effect after next reset.
3.5.2.2.8 External Management VLAN ID
The VLAN ID to be used with external management traffic.
Valid values are 11-100, 110-4094.
The default is 12.
In Unified Connectivity Mode the External Management VLAN ID should be configured to the same
value as the Bearer VLAN ID. Otherwise, it must differ from the Bearer VLAN ID.
A change in External Management VLAN ID will take effect after next reset.
3.5.2.2.9 Local Management IP Address
The IP address of the Local Management interface.
The default is 172.31.0.1.
It is recommended to refrain from changing the Local Management IP Address so that it can always be
used as the known default address for local management.
A change in Local Management IP Address will take effect after next reset.
3.5.2.2.10 Local Management Subnet Mask
The Subnet Mask of the Local Management interface.
The default is 255.255.255.0.
It is recommended to refrain from changing the Local Management Subnet Mask.
A change in Local Management Subnet Mask will take effect after next reset.
3.5.2.3 L1 & L2
The L1 & L2 option enables viewing or updating the parameters of the following Ethernet ports:
DAT1 (Data Port 1): An optional 1000 Base-X optical fiber interface. Applicable only if a suitable SFP
(Small Form-factor Pluggable) optical interface is installed.
DAT2 (Data Port 2): A 10/100/1000 Base-T twisted-pair electrical interface.
DAT3 (Data Port 3): A 10/100 Base-T twisted-pair electrical interface.
Functionality of these ports depends on the Connectivity Mode (see “IP Interfaces” on page 45):