User Manual
Table Of Contents
- System Manual
- BreezeCOMPACT
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBTS System Management
Chapter 3 - Operation and Administration BTS System Management
37
3.1 BTS System Management
The BTS can be managed using any of the following options:
SNMP based management using AlvariSTAR/AlvariCRAFT (or another network management system
customized to support management of the system).
Using Telnet to access the embedded Monitor application.
This chapter describes how to manage the system using the Monitor application. For information on
managing the system using AlvariSTAR/AlvariCRAFT refer to the applicable documentation.
INFORMATION
Even if supported by network routing, remote management from a station behind an MS (via the
wireless link) should be avoided.
INFORMATION
Generally, it is recommended to use the Monitor program only for initial configuration to enable remote
management, and to perform additional configuration and maintenance using AlvariSTAR/AlvariCRAFT.