User Manual

BreezeCOMPACT System Manual
Chapter 2 - CommissioningSystem Initial Verification
Chapter 2 - Commissioning System Initial Verification
28
2.3 System Initial Verification
After powerup, the BTS automatically starts a self-testing procedure to verify that the BTS has been
correctly assembled and installed on site, all its components are functioning properly, and that it is now
ready for commissioning. During the self-test, the LEDs indicate the working status of the various
components.
1 Verify that the BTS is connected to an AC power source.
2 Upon completion of the internal test and boot up (up to 5 minutes), verify that the following LEDs are
lit as follows:
Upon power-up completion, the BTS is ready for basic network definition.
To perform testing:
Table 2-1: BreezeCOMPACT LEDs
Name Description Functionality
PWR Power indication  Off:There is no 4*V to the internal main power supply module
 RED: Power is provided to the unit and the internal main power
supply module is OK
 Green: All the internal digital power supply rails are OK
ALRM Alarm indication  Lights at power up
 Turns off after power up is complete
 Lights on runtime in case of critical failure
GPS GPS status indication  Lights at power up
 Turns off after power up is complete
 Lights when the GPS is reporting at least four satellites or more
reception.
 Blinks (0.5 Sec on, 0.5 Sec off) when the number of satellites
decreases from 4 to 3 or 2 satellites or the min. configured value.
 Turns off when only one satellite is received, or the minimum
configured value of GPS is not operational or not installed.
 Lights again when the unit is regaining satellites reception of 4
satellites or more.