User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationGPS Menu
Chapter 3 - Operation and Administration GPS Menu
81
3.9.1.6 Cock Mode (GPS Chaining)
This paramter is related to GPS Chaining functionality introduced in R5.0
For a cluster of Compacts on the same site, GPS chaining enables the capability to connect one Compact
to the GPS reciever (Master unit) the the rest of the Compacts to get clock feeding from the Mater (Slave
units).
Master should be configured for the BreezeCOMPACT unit which is directly connected to GPS (either
standalone or chaining mode)
Operator needs to be aware during installation which Compact is connected to the GPS and configure it
as a master. For slave units, GPS In cable will be connected from the previous Compact in the chain and
be configured as slave.
The maximum chain units supported is up to 3 units
The following Diagram explain the connectivity for GPS chaining mode:
3.9.1.7 Time Zone Offset From UTC
The offset of the local time from the UTC.
The range is -12:00 to +13:00 in 30 minutes resolution. The default is +00.00.
Syncout
GPSin
Master
Slave
Master
Cat‐5cable
Cat‐5cable
Slave
Cat‐5cable
Syncout
GPSin
Syncout
GPSin