User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationChassis Menu
Chapter 3 - Operation and Administration Chassis Menu
78
3.8 Chassis Menu
The Chassis menu includes the following options:
General
Ports Control
3.8.1 General
The Chassis General menu enables viewing the following read-only general Chassis properties and
status:
HW Version
Serial Number
Temperature (°C)
Operational SW Version
Shadow SW Version
Running SW Version: The source of the current running SW version (operational/Shadow)
Boot SW Version
Active Data Port MAC Address: The MAC address of the active Data port
Data Three MAC Address: The MAC address of Data Port 3
Topology Type: The Topology Type used by the unit. In the current release only One Sector One Carrier
topology (see “System Topologies” on page 10) is supported.
Maximal Frame Size (see details below)
SFP Product Type: The installed SFP type (in any) in DAT1 port. The available options include approved
SFP types, none (SFP not installed), notVerified (a non-approved SFP).
3.8.1.1 Maximal Frame Size
The maximal size (excluding preamble) of frames on the Ethernet port.
The range is from 1400 to 9000 Bytes.
The default is 1578 Bytes.
A change in Maximal Frame Size will take effect after next reset.
* Relevant with Legacy ASN enabled
3.8.2 Ports Control
The Chassis Ports Control menu enables controlling the operation mode of each RF port.