User's Manual

BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBS Menu
Chapter 3 - Operation and Administration BS Menu
62
 ctcQpskOneOverTwoTimesTwo (QPSK 1/2 Repetition 2)
 ctcQpskOneOverTwo (QPSK 1/2)
 ctcQpskThreeOverFour (QPSK 3/4)
 ctcQamSixteenOneOverTwo 16-QAM 1/2
 ctcQamSixteenThreeOverFour (16-QAM 3/4)
 ctcQamSixtyFourOneOverTwo (64-QAM 1/2)
 ctcQamSixtyFourTwoOverThree (64-QAM 2/3)
 ctcQamSixtyFourThreeOverFour (64-QAM 3/4)
 ctcQamSixtyFourFiveOverSix 64-QAM 5/6
The default is ctcQpskOneOverTwo (QPSK 1/2).
A change in Basic Rate for Data will take effect after next reset.
3.7.2.2.1.2.3 DL Data Permutation Base
The permutation base used in the downlink data zone.
The valid range is from 0 to 31.
A change in DL Data Permutation Base will take effect after next reset.
3.7.2.2.1.3 First Zone
The First Zone menu enables viewing/updating the values configured for the following parameters:
 Basic Map Repetition
 Minimum Size
 Maximum Size
 Maximum Map Size
3.7.2.2.1.3.1 Basic Map Repetition
The basic repetition used in the transmission of the maps using QPSK 1/2. The available options are 1, 2,
4 and 6. (1 means no repetitions).
If BS BW=5MHz only values 1, 2, and 4 should be used.
The default is 6 (rate QPSK 1/2 repetition 6).
A change in Basic Map Repetition will take effect after next reset.
3.7.2.2.1.3.2 Minimum Size
The initial size (in symbols) of the first zone.
The available options are 2, 4,....34 (2xN where N=1-17) or -1 for No Limitation. The default is -1 (No
Limitation), meaning that the actual size will be set dynamically according to the configuration.
See limitations in First Zone Minimum Size Recommended Value Range table below. Other values should
be avoided.