User's Manual

BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationSector Menu
Chapter 3 - Operation and Administration Sector Menu
55
The default is none. A valid option must be selected.
A change in Bandwidth will take effect after next reset.
3.6.2.2 Center Frequency
The center downlink frequency of the Radio Cluster, in MHz. The valid values are from f1+0.5BW to
f2-0.5BW, where f1 is the lowest frequency of the band supported by the radio head (see RH Menu,
“General” on page 85), f2 is the highest frequency of the band, and BW is the defined Bandwidth.
The default is 0. A valid value must be configured.
A change in Center Frequenct will take effect after next reset.
3.6.2.3 TX Power
The required tx power of the Radio Cluster, in dBm.
The actually valid range depends on Installed RH Type: The upper limit is set by the Maximum Tx Power
supported by the radio head (see RH Menu, “General” on page 85). The lower limit is the Maximum Tx
Power supported by the radio head minus 10dBm.
The default is 0. A valid value must be configured.
3.6.3 Antenna Association
The Antenna Association menu enables viewing the Antenna and Antenna Port for each antenna
association entry. The selection key for each entry is the RF Port Number(1-4).
A change in Antenna Association will take effect after next reset.
The parameters are presented for each RF Port are:
3.6.3.1 Antenna Number
A number in the range from 1 to 4.
3.6.3.2 Antenna Port Number
A number in the range from 1 to 4.
3.6.3.3 Associated Sector Number
This R5.0 introduced parameters associate the which
For single sector configuration - 1
For Dual Sector Configuration - 1 or 2