User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration BTS Menu
51
3.5.4.1.1 Show
Select this option to view the details of the currently defined SNMP Traps Managers.
3.5.4.1.2 Add
Select this option to add a new SNMP Traps Manager. The SNMP Traps Manager parameters are:
IP Address
Port Number
Community
Enable Traps Distribution
3.5.4.1.2.1 IP Address
The IP address of the Traps Manager.
3.5.4.1.2.2 Port Number
The port number on which the Trap Manager will listen for messages from the Agent. The range is from
1 to 65535. The port on which the management system listens for traps is 162.
3.5.4.1.2.3 Community
The name of the SNMP Read Community used by the Trap Manager. Traps are sent toward those
Managers for which this parameter is configured. A string of up to 10 printable characters,
case-sensitive. The default used by the management system is public.
3.5.4.1.2.4 Enable Traps Distribution
Indicates whether the sending of traps to the management station is enabled or disabled.
3.5.4.1.3 Select
Use this option to select one of the existing SNMP Traps Managers by its IP address. You can then view
the details of the selected manager, update its parameters (excluding the IP address) or delete it.
The Selected Manager submenu includes the following options:
Show: For viewing the details of the selected Manager.
Update: For updating the properties of the selected Manager (for details see Section 3.5.4.1.2
above).
Delete: For deleting the selected Manager from the database.
3.5.4.2 Authorized Managers
An SNMP Manager comprises a pair of SNMP Communities (Community Read Only and Community
Read and Write). A management station is permitted to manage the BTS using SNMP only if it uses one
of the configured SNMP Communities (or a pair of SNMP Communities). A maximum of five SNMP
Managers can be configured. The Authorized Managers submenu enables defining the properties of
management stations that are allowed to manage the BTS using SNMP.
By default the unit is supplied with one Authorized Manager with the following parameters:
Manager Number: 1