User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration BTS Menu
42
3.5.2.2.1 Bearer Subnet Mask
The subnet mask used with the BS Bearer IP Address.
The default is 255.255.255.0.
A change in Bearer Subnet Mask will take effect after next reset.
3.5.2.2.2 Bearer Next Hop Gateway
The IP Address of the Default Gateway for bearer traffic.
The Bearer Next Hop Gateway must be within the range defined by BS Bearer IP Address and Bearer
Subnet Mask.
The default is 0.0.0.0 (must be changed to a valid value if IP addresses of core network equipment is not
within the range defined by BS Bearer IP Address and Bearer Subnet Mask).
A change in Bearer Next Hop Gateway will take effect after next reset.
3.5.2.2.3 Bearer VLAN ID
The VLAN ID to be used with bearer traffic.
Valid values are 11-100, 110-4094.
The default is 11.
A change in Bearer VLAN ID will take effect after next reset.
3.5.2.2.4 Sector 1 - Default Authenticator IP
The IP Address of the default authenticator ASN-GW for Sector 1.
The default is 0.0.0.0 (must be changed to a valid value).
A change in Default Authenticator will take effect after next reset.
3.5.2.2.5 Sector 2 - Default Authenticator IP
The IP Address of the default authenticator ASN-GW for Sector 2.
The default is 0.0.0.0 (must be changed to a valid value).
A change in Default Authenticator will take effect after next reset.
3.5.2.2.6 External Management IP Address
The IP address of the External Management interface. Must be unique in the managed network.
The default is 192.168.1.1.
In Unified Connectivity Mode the External Management IP Address should be within the addresses range
defined by BS Bearer IP Address and Bearer Subnet Mask.
A change in External Management IP Address will take effect after next reset.
3.5.2.2.7 External Management Subnet Mask
The Subnet Mask of the External Management interface.