User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 3 - Operation and AdministrationBTS Menu
Chapter 3 - Operation and Administration BTS Menu
41
Unified: In the Unified connectivity mode the bearer traffic and external management traffic are
unified. The same Ethernet port is used for both traffic types that share the same VLAN ID.
Refer to “L1 & L2” on page 44 for details on the ports used for each traffic type according to the current
Connectivity Mode.
The Management Interface submenu enables viewing the current values and updating the following
parameter:
3.5.2.1.1 Connectivity Mode
The connectivity mode to be used by the system (see description above).
The available options are inband, outofband and unified.
The default is inband.
A change in Connectivity Mode will take effect after next reset.
3.5.2.1.2 Actual Connectivity Mode
The Actual Connectivity Mode is applicable only for the Show menu, indicating the current connectivity
mode. The Actual Connectivity Mode affects configuration rules for Bearer and External Management
parameters.
3.5.2.2 IP Interfaces
The IP Interfaces submenu enables viewing the current values and updating the IP Interfaces’
parameters. The IP Interfaces parameters are:
Bearer Subnet Mask
Bearer Next Hop Gateway
Bearer VLAN ID
Sector 1 - Default Authenticator IP
Sector 2 - Default Authenticator IP
External Management IP Address
External Management Subnet Mask
External Management Next Hop Gateway
External Management VLAN ID
Local Management IP Address
Local Management Subnet Mask
Note that allowed value range for certain parameters may depend on the value configured (or to be
configured) for the BS Bearer IP Address (see “IP Address” on page 70).
Changes in IP Interfaces parameters will take effect after next reset.