User's Manual

BreezeCOMPACT System Manual
Chapter 2 - CommissioningActivating the Unit
Chapter 2 - Commissioning Activating the Unit
29
Refer to “Add” on page 56 for details on these parameters.
2.5.1.2 Using the Management System
1 Right-click the BS node in the navigation tree and select Create to open the New BS window. In the
current release only BS Number 1 option is available for BS Number. Configure the following
parameters:
» BS ID LSB (must be unique in the Radio Access Network)
» Operator ID (the default is 255.243.41. The same Operator ID should be used for all BSs in the
Radio Access Network)).
The new BS will be added to the list of BSs available in the BS node.
2 Select the BS and configure the following parameters (for some parameters you may use the default
value/option):
 In Radio>Basic>General:
» Idle Mode Enable: Mark the check-box to enable Idle Mode. The default is Idle Mode disabled
(not checked).
» Paging Group ID: Applicable only if Idle Mode is enabled. The default is 0 which must be
changed. Paging Group ID should be unique in the Radio Access Network.
» Click Apply.
 In Radio>Basic>Air Frame Structure General:
» Cell ID (the default is 0).
» Segment Number (the default is 0).
» Total Uplink Duration (the default is 3).
» Click Apply.
 In Radio>Basic>Air Frame Structure Zones:
» First Zone-Basic Map (the default is 6).
» Downlink Data Zone-Permutation Base (the default is 0).
» Uplink Feedback Zone-Permutation Base (the default is 0).
» Uplink Data Zone-Permutation Base (the default is 0).
» Click Apply.