User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 2 - CommissioningActivating the Unit
Chapter 2 - Commissioning Activating the Unit
28
2.5 Activating the Unit
To activate the unit you must:
1 Create the BS
2 Define the Antenna(s)
3 Configure Radio Cluster parameters
4 Define Antenna Associations
After properly completing the above steps the unit will start operating using default values for all other
parameters. Additional parameters should be configured according to Radio Network Planning (RNP)
guidelines and other instructions provided by the System Administrator.
This section includes:
Creating the BS
Defining the Antenna(s)
Configuring Radio Cluster Parameters
Configuring Antenna Associations
Applying the Configuration
2.5.1 Creating the BS
2.5.1.1 Using the Monitor Program
Select BS>Add. You will be prompted to configure the following mandatory parameters:
BS Number (must be 1)
BS ID LSB (must be unique in the Radio Access Network)
Operator ID
Cell ID
Segment Number
Total Uplink Duration
Basic Map Repetition
DL Data Permutation Base
UL Feedback zone Permutation base
UL Data Permutation Base
Bearer IP Address
Paging Group ID (if other than 0, should be unique in the Radio Access Network)