User's Manual

BreezeCOMPACT System Manual
Chapter 2 - CommissioningConfiguring Parameters Required for Management Connectivity
Chapter 2 - Commissioning Configuring Parameters Required for Management Connectivity
27
To add an Authorized Manager select BTS>Management>Authorized Managers>Add. You will be
prompted to configure the Manager Number, the Community Read Only and the Community Read and
Write.
To update the default Authorized Manager, select BTS>Management>Authorized Managers>Select, at
the Manager Number prompt enter 1 and select the Update option. You will be prompted to configure
the Community Read Only and the Community Read and Write.
2.4.5.2 Configuring the SNMP Traps Manager
By default the unit is supplied with one SNMP Traps Manager with the following parameters:
 IP Address: 192.168.1.60
 Port Number: 162 (this is the default port number used by the management system)
 Community: public
 Enable Traps Distribution: enable
If different parameters are used by the management system, you should add an SNMP Traps Manager
with the correct parameters (the IP Address of an existing SNMP Traps Manager cannot be updated).
To add an SNMP Traps Manager select BTS>Management>SNMP Traps Managers>Add. You will be
prompted to configure the IP Address, the Port Number, the Community and the Enable Traps
Distribution parameter.
2.4.6 Applying the Configuration
To apply the changes, reset the unit (select BTS>Unit Control>Shutdown operation>Update and select
the reset option).
After the unit reboots, it should be discoverable and manageable from remote by the EMS station.
If you do not use pre-prepared offline configuration files, the following section provide details on how to
configure additional parameters required for activating the unit using either the management system
(after discovering the unit), or the Monitor program.
INFORMATION
Once the unit can be discovered by the management system, the best way to complete the
commissioning process is by using offline configuration files pre-prepared using the Mass Configuration
Wizard. For more details refer to the Using the Mass Configuration Wizard section in the Management
System Infrastructure Manual and to the Using the Offline Tool Wizard section in the Device Driver
Manual.