User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 1 - System DescriptionThe BreezeCOMPACT Solution
Chapter 1 - System Description The BreezeCOMPACT Solution
5
1.1.3.3 Two Sector, Two Carriers (One Carrier per Sector)
Two BSs support two sectors, each with a bandwidth of 5, 7, or 10 MHz. Each Sector is connected to
different 2x2 Antenna directed to two sectors.
This configuration is common using frequency reuse 2, where the two antennas connected to the
BreezeCOMPACT are located back to back.Not applicable for BreezeCOMPACT2000
Figure 1-2: One Sector, Dual Carrier
Figure 1-3: Two Sectors, Two Carriers (One Carrier per Sector)