User's Manual
Table Of Contents
- System Manual
- BreezeCOMPACT - Release 5.0
- About This Manual
- Contents
- Figures
- Tables
- Chapter 1 - System Description
- Chapter 2 - Commissioning
- 2.1 Introduction
- 2.2 BreezeCOMPACT Installation
- 2.3 System Initial Verification
- 2.4 Configuring Parameters Required for Management Connectivity
- 2.4.1 Configuring the BTS Number
- 2.4.2 Configuring the Management Interface Connectivity Mode Parameter
- 2.4.3 Configuring the IP Interfaces Parameters
- 2.4.4 Configuring the L1 and L2 Parameters (if necessary)
- 2.4.5 Configuring the SNMP Authorized Manager and Traps Manager
- 2.4.6 Applying the Configuration
- 2.5 Activating the Unit
- Chapter 3 - Operation and Administration
BreezeCOMPACT System Manual
Chapter 1 - System DescriptionThe BreezeCOMPACT Solution
Chapter 1 - System Description The BreezeCOMPACT Solution
4
Following is a description of each of these topologies:
1.1.3.1 Single Sector, Single Carrier
This is the basic configuration based on a single BS, supporting a single sector 4Tx/4Rx with a bandwidth
of 5, 7, or 10 MHz. This Configuration is recommended for achiving agregated power of 4Tx ports as
well as imporved diversity in Tx and Rx
This configuraion is common for sites of 3 sectors with frequency reuse 3
1.1.3.2 Single Sector, Dual Carrier
Two BSs support a single sector using two different carriers with a total bandwidth of 20 (10+10), 14
(7+7), or 10 (5+5) MHz. The BreezeCOMPACT is connected to one 4x4 Antenna serving, each carrier
could be configured for different frequency. Upon setting this mode, the loadbalancing function will
balance acourding to the number of subscribers.
INFORMATION
In the current release BreezeCOMPACT1000 & 3000 supports all 3 topologies.
Note that BreezeCOMPACT2000 supports only the first topology (Single Sector, Single Carrier)
Figure 1-1: One Sector, One Carrier