User's Manual

Chapter 2 - CommissioningIntroduction
Chapter 2: Commissioning
Introduction
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
BreezeCOMPACT System ManualBreezeCOMPACT System Manual
35
2.1 Introduction
After completing the installation process, some basic unit's parameters must be configured locally using the Monitor
program in order to enable discovery by the Element Management System and remote management of the unit.
Refer to “Monitor Program” on page 46 for information about accessing the Monitor program using Telnet and how to use it.
It is recommended to reset the unit to its factory default values before proceeding with following configuration steps:
Enter the Monitor program and select BTS > Unit Control > ShutDown Operation > Update > resettoFactoryDefault.
You will be prompted to confirm the requested action.
2.2 BreezeCOMPACT Installation
For detailed installation instructions, refer to the BreezeCompact Quick Installation Guide.