System Manual

BreezeCOMPACT System Manual
88
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
 Check in system events that upload-config-file-completed by command:
show notification stream alarm
 Restore configuration file
request config-file restore-config-file
This action will load (restore)the configuration file from the disk and replace the database.
Are You sure? [no,yes] y
yes
 Check in system events that restore-config-file-completed by command:
show notification stream alarm
 Reboot eNB to apply changes
request reboot reboot
3.3.6
Configuring Via BreezeVIEW
The following describes how to perform a full configuration via BreezeVIEW.
¾ To configure via BreezeVIEW:
1
Access BreezeVIEW as a
admin
.
2
In the device list, select the number of the device to be edited.
3
Define the device’s general information, as shown below.
Figure 49: Device Information
4
Define the device’s management information, as shown in above.