System Manual
BreezeCOMPACT System Manual
68
Chapter 3: Operation and Administration
Procedures
BreezeCOMPACT Full Configuration via CLI
Figure 39: BREEZEVIEW -ENB deployment tab when in DualCarrier
On BREEZEVIEW->devices->ENB ->cell0 tab:
Figure 40: BREEZEVIEW -ENB CELL0 deployment tab when in DualCarrier
On BREEZEVIEW->devices->ENB ->cell1 tab:
Figure 41: BREEZEVIEW -ENB CELL1 deployment tab when in DualCarrier
3.3.2.3.8
Dual Carrier Aggregation:
The Dual Carrier Aggregation topology enables in addition to a double-capacity
BreezeCOMPACT, an up to double downlink capacity on selected CPE. In this mode, the
BreezeCOMPACT behaves like two 2x2 eNodeBs (up to double downlink capacity vs split
mode) and enables selected CPE’s to aggregate downlink traffic from both carriers.
On BreezeCOMPACT CLI from BreezeCompact% prompt perform the following in order to set:
set deployment topology DualCarrierAggregation
set cell0 general central-frequency <Frequency 0 in MHZ>
set cell1 general central-frequency <Frequency 1 in MHZ>
set cell0 general phy-cell-id [physical cell ID 0]
set cell1 general phy-cell-id [physical cell ID 1]
Perform commit procedure as per 3.1
When running: show deployment topology
Result is: topology DualCarrierAggregation
When running: show ran rh-ports-admin-state